Acrosser AR-B1551 - Manual (Page 15)

AR-B1550 User’s Guide
13
3. SETTING UP THE SYSTEM
This section describes pin assignments for the system’s external connectors and the jumper settings.
! Overview
! System Setting
3.1 OVERVIEW
AR-B1550 Pentium Grade Firewall CPU Board with Ehternet , DOM. This section provides the hardware’s jumper
settings, the connectors’ locations, and the pin assignments. The #1 pin assignments have all been designed on the
right side of the board with a “block” indication on the diagram.
B
External System Location
3.2 SYSTEM SETTING
Jumper pins allow you to set specific system parameters. Set them by changing the pin location of jumper blocks.
(A jumper block is a small plastic-encased conductor that slips over the pins.) To change a jumper setting, remove
the jumper from its current location with your fingers or small needle-nosed pliers. Place the jumper over the two
pins designated for the desired setting. Press the jumper evenly onto the pins. Be careful not to bend the pins.
CAUTION: Do not touch any electronic components unless you are safely grounded. Wear a grounded wrist strap
or touch an exposed metal part of the system unit chassis. The static discharges from your fingers can
permanently damage electronic components.