Acrosser AR-R5800 - Manual (Page 57)

Revision: 1.2
Return Value: If the function gets the values successfully, it returns 0. If any error, it
returns –1.
4. Syntax:
i32 setChLevel( u8 val )
Description: Set the status bits of GPIO Output ports according to the variable ‘val’. The status
bits at the ports which are configured as input will not be affected.
Parameters: The parameter ‘val’ is an unsigned character. If a GPIO port is configured as an
Output port, a ‘1’ bit at ‘val’ directs the corresponding port to output a ‘1’. A ‘0’ bit directs this
port to output a ‘0’. If a GPIO ports is configured as an Input port, the setting to these input port
is ignored.
Return Value: If the function sets the values successfully, it returns 0. If any error, it
returns –1.
Watchdog
1. Syntax:
u8 getWtdTimer(void)
Description: This function read the value of the watchdog time counter and return it to the
caller.
Parameters: None.
Return Value: This function return the value of the time counter and return it to the caller as an
unsigned integer.
2. Syntax:
void setWtdTimer( u8 val )
Description: This function sets the watchdog timer register to the value ‘val’ and starts to count
down. The value could be 0 ~ 255. The unit is second. Setting the timer register to 0 disables
the watchdog function and stops the countdown.
57