Accutone WT89 - Manual (Page 5)

[ inspiring people, inspiring change ] B. INSTALLING YOUR WT89 HEADSET
putting everything together!
Installation Installation
7 8
B4. pairing the wireless headset with your telephone
Different telephones have different
settings, in some cases you will have to
adjust your wireless headset to pair with
your specific telephone.
To see whether your headset needs
adjustment, put on your headset (after it is
fully charged and properly connected),
press the Answer Button (5) on your
headset for the lifter to uplift the handset,
or manually pick up the handset if you
don’t have a lifter.
If you hear a dial tone, the wireless headset works with your telephone. But if
you do not hear a dial tone, pair the two by sliding the Configuration Switches
(L) & (M) until you hear a dial tone.
M
L
L M
Now make a call using your telephone.
If the person on the other end hears you
perfectly, the pairing is completed.
If you hear the caller, but s/he cannot
hear you or the volume is very low, slide
the Configuration Switches (L) & (M),
until you find the best setting. Note that
out of the 12 possible combinations,
there may be more than one optimal
setting.
B5. adjusting signal amplification
Level 1
Level 2
Level 3
Level 4
In some cases, the default volume for the microphone or the speaker of the
telephone is not sufficient for the wireless headset. The WT89 allows extra
amplification for these cases.
On the bottom of the device, you find two small switches allowing four levels
of settings each for the Mic Amp Adjustment (N) and Speaker Amp
Adjustment (O). Follow the illustration above, and make the adjustments
corresponding the area you need to amplify. Level 4 gives the highest volume.
O N
B6. re-registering headset with base unit
The WT89 headset and base unit comes pre-registered as a pair. But in case
the headset loses synchronization with the base, you can re-register it by:
1. Hold down the Page Button (D) of the base unit until it flashes blue
2. Remove the headset, press the Answer Button (5) until it also flashes blue
3. Press the Tone Decrease Button (F) of the base unit 3 times
4. The indicator on the base unit flashing blue slows down
5. Press the Answer Button (5) on the headset once
6. Indicator of the base unit flashes quicker, a click sound follows
7. Click sound indicates successful pairing, press Answer Button(5) to retest