3DLABS VP - Manual (Page 9)

Installation
3. If necessary, remove the back panel cover from the slot into which you are going to install your
3Dlabs Graphics Accelerator Card, using the Phillips-head screwdriver you should have handy.
4. If an anti-static wrist strap was included in your box, attach it to your wrist and attach the other
end to a bare metal (as opposed to painted or sticker covered) surface on your system’s chassis.
5. Remove your new 3Dlabs Graphics Accelerator Card from its anti-static packaging. Write down
the serial number for product registration and future use. The serial number is located on a board
label and looks like this:
136001B123456 Made in XXX Week XXXX
6. Place the card into the correct slots and seat it firmly. See your system documentation for
instructions on securing the card to the chassis. Loose cards and connections can cause grounding
and operating problems.
7. Remove the anti-static wrist strap, if used, and replace the cover on your system.
3Dlabs Wildcat VP Graphics Accelerator Card User's Manual 3