Dacor ID30 - Manual (Page 6)

Preparing for Installation
The floor must be level and all cut-out surfaces at right
angles. The dishwasher must be secured to the adjacent
cabinets using the anti-tip brackets for safety and proper
operation.
Plan the installation so that the appliance can be removed
if service is required.
Planning the Location
Carefully check the location where the dishwasher is to
be installed. Place it in a location with convenient access.
Make certain that electrical power can be provided in the
selected location.
IMPORTANT: Follow all cabinet and countertop minimum
dimensions shown below to insure safe operation.
Plan the installation as shown so that all minimum product
dimensions are met or exceeded (see page 3). Dimensions
shown provide minimum clearances, unless otherwise
noted.
CUT-OUT FRONT VIEW
WARNING
Observe all governing codes and ordinances during planning and installation. Contact your local building department
for further information.
Tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
CUT-OUT SIDE VIEW
ED or ID30 – 30" Min. (762mm)
Utilities Access Hole
34”
(864mm)
to
36 1/4"
(921mm)
5"
(127mm)
8"
(203mm)
Anti-tip anchor into material under
countertop or adjacent cabinets
90˚ 90˚
24" Min.
(610mm)
Min. Countertop 25" (635mm)