Denon AVR-1707 - Manual (Page 7)

Getting Started Getting Started
3
ENGLISH
ENGLISH
About the remote control unit
In addition to controlling the AVR-1707, the attached remote control
unit (RC-1049) can also be used to control the following products:
q DENON component products
w Component products other than DENON:
• Set using the preset memory function ( page 46).
Cautions on installation
Wall
Note
Note:
For heat dispersal, do not install this unit in a confined space
such as a bookcase or similar enclosure.
Inserting the batteries
q Remove the remote control
unit’s rear cover.
w Set two R6P/AA batteries in
the battery compartment in
the indicated direction.
e Put the rear cover back on.
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated nearby the unit.
(The attached batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
direction, following the “<” and “>” marks in the battery
compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries
in flames.
• Remove the batteries from the remote control unit when you do
not plan to use it for an extended period of time.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• Remove the batteries from the remote if it will not be in use for
long periods.
Operating range of the remote control unit
30°
30°
Approx. 7 m
• Point the remote control unit at the remote sensor when operating
it.
• The remote control unit can be used from a distance of approximately
7 meters, at a horizontal angle of up to 30° with respect to the
sensor.
NOTE:
• It may be difficult to operate the remote control unit if the remote
sensor is exposed to direct sunlight or strong artificial light.