Dolmar HEDGE HT-355 - Manual (Page 6)

6
•
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be
cut with shears down to the hedge trimming level.
007559
CAUTION:
•
Do not cut off dead trees or similar hard objects.
Failure to do so may damage the tool.
Hold the trimmer with both hands pull the switch trigger
A or B and move it in front of your body.
009413
When operating the hedge trimmer, keep extension cord
behind trimmer.
As a basic operation, tilt the blades towards the trimming
direction and move it calmly and slowly at the speed rate
of 3 - 4 seconds per meter.
009284
1
2
3
009285
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
009286
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves'
being thrown away.
009287
To cut a hedge side evenly, it helps to cut from the
bottom upwards.
009288
Trim boxwood or rhododendron from the base toward
the top for a nice appearance and good job.
009289
1. Trimming
direction
2. Tilt the blades
3. Hedge surface
to be trimmed