Luxman LR-8500 - Manual (Page 16)

- 16 -
DELAY
- Press this button to begin the process for setting the
delay times used LR-8500 when processing surround
sound or to compensate for video-to-audio delays
caused by the use of digital sources or video displays.
SET UP
- Enter or exit the system setup menu. (DVD only)
ENTER
Press to enter setting.
DIGITAL
- Press this button to assign one of the digital inputs to a
source
MENU
- Access the menu on a DVD disc. (DVD only)
OSD
- Press this button to activate the ON-Screen
Display(OSD) system used to set up.
- Select to NTSC or PAL (press this button for more than
3 seconds).
VOL (^/v)
Press to adjust volume.
MULTI
Press to select ZONE II ON/OFF, ZONE II INPUT and
ZONE II Volume.
MUTE
Press to activate the mute function.
33
32
31
30
29
28
27
POWER
When used in the room where the LR-8500 is located,
press this button to place the unit in Standby. When it
is used in a remote room with a sensor that is con-
nected to the ZONE II IR Input jack, this button turns
the ZONE II system on and off.
AMP
Press this button to turn on the LR-8500. The input in
use when the unit was last on will be selected.
AM/FM Tuner Select Button
Press this button to select the Tuner as the input to
the ZONE II system. Press it again to change between
the AM and FM bands.
TUNING Up/Down
When this remote is used in the same room as the LR-
8500, these buttons may be used to change the fre-
quency of tuner.
PRESET Up/Down
When the LR-8500's tuner is selected as the input
source, these buttons will move up or down through
the list of stations that have been stored in the preset
memory.
Volume Up/Down Buttons
When used in the room where the LR-8500 is located,
press this button to raise or lower the volume in that
room. When used in a remote room with a sensor that
6
5
4
3
2
1
Control Functions
4
8
2
9
5
6
3
7
1
ZONE II Remote Control Unit