DCS CMOTTK30 - Manual (Page 2)

Installing Trim Kit
1. Cut opening in the cabinet face per the following dimensions:
Height: 19-3/16” + 1/16”, –0
Width: 25-3/4” + 1/16”, –0
Note: Refer to diagram on the following page. The minimum
cabinet depth is 20”. When installing the Microwave
and Trim Kit in combination with a Wall Oven or
Warming Drawer, please follow the recommendations
in the Microwave Installation/ Use & Care Manual.
2. Add adequate platform base support in the bottom of the
cabinet for trim kit base to rest on.
3. Mark a centerline on the front edge of the cabinet bottom
(Fig. 05).
4. Place trim kit base and align centerline mark to the triangular
notch on the front edge of the base (Fig. 06).
5. Drill 1/8” pilot holes in the cabinet using the base as a template
and install a screw through the base into the cabinet to prevent
the base from shifting (Fig. 07).
6. Insert Microwave into opening on top of the base. The
Microwave feet should sit in the recesses on the base for correct
alignment. The Microwave should be plugged in at this point.
7. Place the right and left mounting bracket supports by resting
the bottom edges of the supports on the bottom of the cutout
(Fig. 08). The long flange on the side supports should clear the
side of the cutout by approximately 1/16” (see Fig. 09). Install
top screws into the cabinet face by first drilling 1/8” pilot holes
(see inserts 3 and 4).
8. Install trim kit face by inserting top pins of trim into
corresponding sockets on the top corners of clip support plates
(see insert 1).
9. Finish the assembly by inserting the bottom pins into the
corresponding sockets on front edge of the base (see insert 3).
Check for proper door opening clearances.
1/16"
Fig. 09
Fig. 05
Fig. 06
Fig. 07
Fig. 08
Bracket
Support
on the
bottom
of cutout