Hyundai H-CDM8045 - Manual (Page 14)

14
General operation
Reset the unit
Operating the unit for the first time or after replacing the car battery, you must reset the unit.
Press REL button on the panel to open the panel and press the RESET hole with a point object to restore the unit
to the original factory settings.
Power button
Press PWR button on the RC or POWER on the front panel to turn on the unit.
Press it to switch the set off.
Note: After the unit is off, the volume level is rized during the area between 6 and 30. If the volume level is set
less than 6, it will resume to 6; if it is higher than 30, it will resume to 30; if it is between 6 and 30, it still stores in
the status which
you set.
Volume control
Volume adjust
Press the VOLUME ( , ) buttons on the RC or rotate the VOLUME knob on the panel to adjust the volume
level.
Setting the sound characteristics
Press repeatedly the SEL button on the remote controller or VOLUME knob on the front panel to select the audio
mode such as VOL (volume), BAS (bass), TRE (treble), BAL (balance), FAD (fader), then press the ,
buttons on the front panel or the remote controller to adjust the settings for each mode.
Note:
If turning off the power all the settings of each mode will be saved.
If turning off the ACC power all the settings will become as they were set on the plant as current.