Danby DBD5L - Manual (Page 18)

18
CARE AND CLEANING
CAUTION: DO NOT USE A DISHWASHER TO CLEAN THE BEVERAGE
DISPENSER, SPARE PARTS OR ACCESORIES.
NOTE: Handling beverages requires very special attention to cleanliness and
hygiene. Clean the beverage dispenser, spare parts, and accesories thoroughly
after each use.
CLEANING THE OUTSIDE OF THE BEVERAGE DISPENSER
Always unplug the beverage dispenser before cleaning. Do not use a hard brush or
sponge. Use a small amount of soap in water with a soft cloth. To dry, use a dry soft
cloth or towel.
Never immerse the beverage dispenser in water or other liquids. Do not let water or
liquid get into the casing of the unit. Never use very hot water.
Remember to rinse out the drip tray if it should be filled during use, and clean
thouroughly after each use.
CLEANING THE INSIDE OF THE BEVERAGE DISPENSER
Soak up all beverage or liquids that have spilled in the cooling compartment; Clean the
cooling compartment with soapy water and a soft cloth.
Clean and rinse the tap with a soft cloth and water
CLEANING THE SPARE PARTS AND ACCESORIES
Thoroughly clean all TUBES, ADAPTERS, and CONNECTORS with light soap and
warm water. For the ADAPTERS to be properly washed and rinsed, the
CONNECTORS and TUBES need to be attached. This will provide access to
inaccessible areas within the ADAPTERS. Make sure to remove the “O-rings” in the
ADAPTERS and CONNECTORS to clean inaccessible areas. Rinse thoroughly under
warm flowing water to remove any residual soap and beverage residue.
Repeat if necessary.
Air dry all washed parts and accessories for 24 hours.
NOTE: Do not pre-install the accessories. Store the accessories in a separate box or
bag outside of the beverage dispenser.