Danby DBD5L - Manual (Page 13)

CONNECTING THE BEVERAGE DISPENSER
13
Preparing the Beverage Container
USING THE WHITE BEVERAGE CONTAINER ADAPTER
To connect the WHITE ADAPTER to the 5L Beverage
Container, follow these instructions.
NOTE: MAKE SURE ALL COMPONENTS ARE
PROPERLY SANITIZED PRIOR TO EACH USE.
PREPARING THE BEVERAGE CONTAINER
To prepare the Beverage Container, please follow these
instructions:
BEVERAGE CONTAINER
WHITE ADAPTER
YELLOW RISING PIPE
AIR-CONNECT TUBE
DISPENSING TUBE WITH BLACK STOPPER
1. Fill the beverage container with a beverage of your
choice. Make sure to fill only to the lower edge of the
handles. Fasten the RISING PIPE securely into the WHITE
ADAPTER (See Figure 12).
GETTING THE CONTAINER READY
2. Insert the RISING PIPE and the WHITE ADAPTER into
the container. Position the inlet grooves on the ADAPTER
over the handles. Make sure it is securely fastened (See
Figure 13).
SETTING UP THE DISPENSING TUBE
3. Pull the tap handle completely down and push the
DISPENSING TUBE into the tap. Make sure the BLACK
STOPPER fits securely in the inlet just before the tap (See
Figure 14)
4. Make sure the DISPENSING TUBE is slightly exposed
below the tap (See Figure 14).
SETTING UP THE AIR CONNECT TUBE
5. Connect the AIR-CONNECT TUBE to the AIR OUT valve
located in the back of the unit. Place the CLIP over the
valve to ensure an air-tight seal.
Figure 13
Figure 14
Figure 12
FASTEN UNDER
GROOVES
FASTEN
RISING
PIPE INTO
WHITE
ADAPTER
(turn in
clockwise
Direction)
BLACK STOPPER
TUBE IS
EXPOSED