Daewoo SD-9500P - Manual (Page 31)

30
More Functions
Clock / counter display
■ The counter counts in real time from the point you load the cassette. This does not have to be its
beginning! The counter does not count unrecorded parts of the tape.
■ If you rewind beyond the zero position, the counter counts in negative values (e.g. – 0:01:15).
Each time you press [DISPLAY] button,
Press 1x: Time and date+current status
Time and date
Press 2x: Counter+current status counter
Press 3x: disappear.
But if you press [CLK/CNT] button, the display window will change to clock
or counter depending upon selection made.
STOP SP PR01 ARD
14:00 08/06 E180 00:48
STEREO ON
V
Accessing counter zero position
The player will wind to the position 0:00:00 and stop.
Remaining time and cassette length
When you want the player to show the time remaining from the current player tape position (to find out if
there is sufficient space for a recording, for example).
To ensure the remaining time shown is accurate, select the length of cassette currently loaded by selecting
the function and specifying the correct length.
• Remaining time display is
only possible when the
cassette is loaded.
TAPE CONTROL TAPE REMAIN
E-240 01:27
TAPE REMAIN
GO TO ZERO
COUNTER RESET
INDEX+
INDEX-
E-180
E-240
E-300
PR+/-:SELECT
OK:CONFIRM SETUP:END
PR+/-:SELECT
OK:CONFIRM SETUP:END
REW SP
GO TO ZERO
0:02:13
Resetting the counter to zero
Reset the counter. COUNTER RESET
0:00:00
Call the player’s “SETUP”,
choose “TAPE CONTROL”.
• If you don’t wind tape (PLAY, FF, REW,...), the tape remain time doesn’t appear.
• If using a broadcast signal for timer recording, press the button to display the VPS/PDC icon.