Safety instructions, Insert handle, Conversion into a hand appliance (fig. 4) – AEG VAMPYRETTE 330 User Manual
Page 7: Switching on and off (fig. 6)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Safety instructions
• The supply voltage must be the same as
the operating voltage (see rating plate on
underside of vacuum cleaner)!
• The circuit for the socket used must be
protected with a fuse of at least 10 A.
• Before maintenance or cleaning or before
connecting additional appliances, ensure
that the appliance is switched off and
unplugged from the mains supply.
• Never use the flex to pull the mains plug
out of the plug socket.
• Do not operate the appliance If:
- the flex Is damaged
- the housing shows visible signs of
damage.
• Avoid running over the supply lead with the
appliance, suction brush, or electric
suction brush. The Insulation may be
damaged.
• Repairs to electrical appliances should .
only be carried out by a trained electri
cian. Improperly performed repairs may
place the user at serious risk.
• If your vacuum cleaper has a fault, please
therefore contact your electrical retailer or
the AEG Service Centre direct.
• Make sure that a paper dustbag and
MICROFILTER are always inserted.
• Let shampooed carpeted floors fully dry.
Never use your vacuum cleaner to vacuum
liquids, since It may otherwise be
damaged. Thé protection against electric
shock may also be impaired.
• If the appliance Is wrongly operated
or used for a purpose other than that for
which it is intended, no liability can be
accepted for any possible damage.
• Never use ydur appliance to vacuum
matches, glowing embers, or cigarette-
ends. Avoid vacuuming hard pointed
objects, since they may damage the appli
ance or paper dustbag.
“CE” This appliance complies with the follow
ing EC Directives: - 72/23/EEC of 19. 02.1973
- Low Voltage* Directive - 99/336/EEC of
03. 05.1989 (including Amentment Directive
92/31/EEC) - EMV Directive.
Insert handle
First of all, insert the handlegrip into the
tubular handle by pressing down the locking
knob, taking care that the knob comes to rest
in the hole provided.
Fig. 3: Insert the handle into the top of the
appliance and secure it by means of the lock
nut. The handlegrip and cable clips must point
backwards. Insert the electric lead into the
plug aperture on the handlle next to the upper
cable clip.
Conversion into a hand appliance
(fig. 4)
Detach the handle from the appliance, sepa
rate the handlegrip from the handle tube by
pressing on the knob and pulling, and insert it
in the appliance in place of the handle.
The handlegrip of the handle tube and the
handle on the appliance enable the appliance
to be used with ease and comfort on uphols
tery, mattrasses, etc.
Fig. 5 : The nozzles are connected by pushing
and twisting and disconnected by pulling and
twisting.
Switching on and off (fig. 6)
Switch your vacuum cleaner on or off with the
on/off button (A).
If you have connected other electrical
appliances with high connected load on the
same circuit and switch them on simulta
neously with your vacuum cleaner, the fuse
may cut out. On the VAMPYRETTE, this can be
avoided by setting the slide control to MIN
before switching on and then controlling the
setting to a higher level after switching on.
10