Dynalink ADSL Router/ RTA770 - Manual (Page 3)

Default Configuration for Australia
This router is shipped with the following factory default settings.
Router IP address
192.168.1.1
Subnet mask 255.255.255.0
VPI 8
VCI 35
Connect mode PPPoA VC-MUX
NAT enabled
DSL line mode auto select G.DMT / T1.413
WAN IP dynamic
DHCP enabled
DNS relay on
UPnP IGD enabled
Firewall incoming on
Firewall outgoing off
Router configuration & management:
User name
admin
Password admin
Telnet password admin
If your ISP specifies that your ADSL service is PPPoE, connect mode must be
changed to PPPoE LLC/SNAP. Instructions will follow. Check with your ISP if
you are unsure of the type of service you have subscribed to. Advanced users
who have other setup preferences should first read the User’s Manual.
Before you start
Make sure your computer has these installed:
Ethernet or USB port
TCP/IP protocol enabled
A web browser, Internet Explorer 5.0/Netscape 6 or better.
Obtain your Internet account information from your ISP:
Login user name and password
Public IP address (only if you subscribe for static IP)
DNS server IP (only if specified by ISP).
1
2