Dacor 65513REV.B - Manual (Page 4)

2 3
Information about Repair Service
1. Servicing. Do not attempt to service this
product yourself as opening or removing
covers may expose you to dangerous
voltage or other hazards. Refer all servicing
to qualified service personnel.
2. Damage requiring service. Unplug this
product from the wall outlet and refer
servicing to qualified service personnel
under the following conditions:
a. When the power-supply cord or plug is
damaged.
b. If liquid has been spilled, or objects
have fallen into the product.
c. If the product has been exposed to
rain or water.
d. If the product does not operate
normally by following the operating
instructions. Adjust only those controls
that are covered by the operating
instructions as an improper adjustment
of other controls may result in damage
and will often require extensive work
by a qualified technician to restore the
product to its normal operation.
e. If the product has been dropped or
damaged in any way.
f. When the product exhibits a distinct
change in performance, this indicates
a need for service.
3. Replacement parts. When replacement
parts are required, be sure the service
technician has used replacement parts
specified by the manufacturer or have the
same characteristics as the original part.
Unauthorized substitutions may result in
fire, electric shock, or other hazards.
4. Safety check. Upon completion of any
service or repairs to this product, ask the
service technician to perform safety checks
to determine that the product is in proper
operating condition.
5. heat. The product should be situated
away from heat sources such as radiators,
heat registers, ranges, or other products
(including amplifiers) that produce heat.
Cart Mounting
The following general hazards could result in
personal injury or product damage. Specific
warnings and cautions are found in relevant
sections of the operating instructions.
1. Read the instructions. All safety and
operating instructions should be read
before operating the DKEC.
2. Retain the instructions. The safety and
operating instructions should be retained
for future reference.
3. heed warnings. All warnings on the
product and in the operating instructions
should be adhered to.
4. follow instructions. All operating
instructions should be followed.
5. Cleaning. Unplug the DKEC from the
wall before cleaning it. Do not use liquid
cleaners or aerosol cleaners. Clean the unit
with a damp cloth.
6. Attachments. Do not use attachments
which are not recommended by the
manufacturer.
7. Do not use the unit near water. For
example, near a bath tub, wash bowl,
kitchen sink, or laundry tub; in a wet
basement; or near a swimming pool; and
the like.
8. Carts and Stands. The DKEC should
be placed on a cart or stand designed to
securely support the weight of the unit.
When mounted on a cart or stand, the
DKEC should be moved carefully. Sudden
stops, excessive force, or uneven surfaces
may cause the cart to overturn.
9. Accessories. Do not place this product on
an unstable cart, stand, tripod, bracket, or
table. The product may fall causing serious
injury to a child or an adult and serious
damage to the product.
protection Against Electric Shock
1. power sources. This product should only
be operated from the type of power source
indicated on the marking label. If you are
not sure of the power supply to your home,
consult your product dealer or local power
company.
2. Grounding or polarization. This product is
equipped with a three-wire grounding-type
plug, a plug having a third grounding pin.
This plug will only fit into a grounding type
power outlet. This is a safety feature. If you
are unable to insert the plug into the outlet,
contact your electrician to replace the
obsolete outlet. Do not defeat the safety
purpose of the grounding-type plug.
Ground Clamp
Electric Service
Equipment
Antenna Lead Wire
Antenna discharge unit
(NEC section 810-20)
Power Service Grounding
Electrode System
Ground Clamps
(NEC ART 250 Part H)
Example of Antenna Grounding
General Warnings and Cautions
3. power-cord protection. Power-supply
cords should be routed so that they are
not likely to be walked on or pinched by
items placed upon or against them, paying
particular attention to cords at plugs,
convenience receptacles, and the point
where they exit from the product.
4. Outdoor antenna grounding. If an outside
antenna or cable system is connected to
the product, be sure the antenna or cable
system is grounded so as to provide some
protection against voltage surges and
built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA 70,
provides information with regard to proper
grounding of the mast and supporting
structure, grounding of the lead-in wire
to an antenna discharge unit, size of
grounding conductors, location of antenna-
discharge unit, connection to grounding
electrodes, and requirements for the
grounding electrode.
5. Lightning. For added protection for this
product during a lightning storm, or when
it is left unattended and unused for long
periods of time, unplug it from the wall
outlet and disconnect the antenna or cable
system. This will prevent damage to the
product due to lightning and power-line
surges.
6. power lines. An outside antenna system
should not be located in the vicinity of
overhead power lines or other electric
light or power circuits, or where it can fall
into such power lines or circuits. When
installing an outside antenna system
extreme care should be taken to keep from
touching such power lines or circuits as
contact with them might be fatal.
7. Overloading. Do not overload wall outlets,
extension cords, or integral convenience
receptacles as this can result in a risk of
fire or electric shock.
8. Object and liquid entry. Never push
objects of any kind into this product through
openings as they may touch dangerous
voltage points or short-out parts that could
result in a fire or electric shock. Never spill
liquid of any kind on the product.