D-Link DI-514 - Manual (Page 24)

24
The DI-514 provides some predefined applications in the table on the bottom
of the web page. Select the application you want to use and enable it.
Note! Only one PC can use each Special Application tunnel.
Trigger Name: This is the name referencing the special application.
Trigger Port: This is the port used to trigger the application. It can be either
a single port or a range of ports.
Trigger Type: This is the protocol used to trigger the special application.
Public Port: This is the port number on the WAN side that will be used to
access the application. You may define a single port or a range of ports. You
can use a comma to add multiple ports or port ranges.
Public Type: This is the protocol used for the special application.
Schedule: This is the schedule of time when the special application will be
enabled.
Filters
Filters are used to deny or
allow LAN (Local Area
Network) computers from
accessing the Internet.
The DI-514 can be setup
to deny internal
computers by their IP or
MAC addresses. The DI-
514 can also block users
from accessing restricted
web sites.
IP Filters
Use IP Filters to deny
LAN IP addresses from
accessing the Internet.
You can deny specific port
numbers or all ports for the specific IP address.
IP: The IP address of the LAN computer that will be denied access to the
Internet.
Port: The single port or port range that will be denied access to the Internet.
Schedule: This is the schedule of time when the IP Filter will be enabled.
Advanced > Filters