Audiovox CMT-1000 - Manual (Page 5)

PLACING TELEPHONE CALLS SCRATCH-PAD DIALING
To Place a Call
1. Enter telephone number with the handset on-hook
or ofF-hook. The last ten digits of the dialed number
are displayed on the digital readout.
2. If a dialing error is made, press
the telephone number again.
then enter
3. Press Then indicator will light. You
may lift the handset from the cradle either before or
after the called party answers to proceed with your
conversation.
If the Call Falls to go Through
1. If you hear the “reorder” signal, hang up and try again.
If there were no dialing errors, press |SBWP| for
automatic redial (re-dialing is not necessary).
2. If the “intercept” signal is heard, hang up. It then will
be neces.sar\' for you to redial the correct number.
Terminating a Call (Hanging Up)
Press teNDl, or replace the handset in the cradle, The
I IN USE 1 indicator will go our.
To Receive Calls
1. When rhe telephone rings, lift rhe handset to answer.
Thefi^ USilindicator will light,
2. If the handset is out of the cradle when ringing starts,
pf^^ss to answer the call.
3. If you desire to enter the call in the “hands ft-ee” mode,
leave the handset in the cradle, press.. and then
for operation through the headset.
This feature permits you, while engaged in a
conversation, to enter a number to be re-dialed (or
store a number in memory) without hearing annoying
tones over your circuit.
When In the Hands-Free Mode
1. Press llQNEl , then enter the telephone number. The
headset will remain active, but the tones will not be
heard.
2. If necessary', press (yt)u will hear a tone); then
enter the memory' address (01 through 30). Wait for
another tone.
3. Press [fa-EARj , You will then hear three tone.s, after
which you may prtx'eed with the next number,
4. To exit the “scratch pad” mode, press the
button again.
When Not in the Hands-Free Mode
1. Press . The handset is muted, and you will
hear the other party’s voice from the loudspeaker,
2. Enter the telephone number (you may enter the
number with the handset either “off-hook” or
“on-hook’’).
3. If necessary, press (STGRI^l (you will hear a
“beep"); then enter the memory address (01 through
30), ’Wait for ant)ther “beep,”
4. Press . You will then hear three “beeps,”
after which you may prcxeed with the next number.
5. To return to normal conversation: if “off hook"
press the ^ button; if “on hook” lift the
hand,set ffom tiie :radle.
To Place a Call to a Number in the Memory
1. Press {HECAtt j, then enter the memory address (01
through 30). The last ten digits of the number will appear
on the readout. If the number is longer than 10 digitSi
hold down the second digit of the rhemory address
(after pressing
) to see the prefix.
2. Press |^Nt>i . The indicator will light as the
call is placed.
HORN ALERT
1. Press button until the indicator
lights. Turn off the ignition .s-witch, but leave the car
telephone power switch ON. If necessary, kxk the unit.
2. 'When a call is received, the unit will sound the horn
or flash the lights five times, depending on how it has
been wired.
3. This mode is automatically deactivated when the
ignition switch is turned to the “on" or “accessory'”
positions, or, to prevent di.scharging the battery, after
IVi hours.