Denso OFFICE PRO 12 - Manual (Page 16)

10
OPERATION (cont.)
Operating in COOL Mode
➀ The unit can be operated in COOL mode by pressing the COOL
ON/OFF button (LED illuminates).
NOTE: In COOL mode the unit can only be turned off by pressing
the COOL ON/OFF button again, not by pressing the fan buttons.
➁ Change the fan speed by pressing the HIGH or LOW fan buttons.
➂ Change the temperature set point by pressing the SET TEMP
buttons (
▼
/
▲
).
NOTE: When turning the unit on, the set point and fan speed are
determined by the last operating mode (program mode not in-
cluded).
Operating in Fan Only Mode
➀ The unit can also be operated in Fan Only mode by pressing either
the HIGH or LOW fan buttons (LED illuminates).
➁ The unit can then be turned off by pressing the fan speed button
that is illuminated.
Changing from Fan Only Mode to COOL Mode
The COOL mode can be activated while the unit is operating in Fan Only
mode. To do this, simply press the COOL ON/OFF button (LED illumi-
nates).
NOTE: The Fan Only mode will not operate after the COOL mode
has been activated. After the COOL mode has been activated, the
unit cannot be turned off by pressing the fan buttons. The COOL
ON/OFF button must be pressed.