Demco CHRYSLER SEBRING CONVERTIBLE TP20108 - Manual (Page 3)

2. Remove screws from wheel well to facia on each
side.
3. Remove plastic wheel well extension, two plastic push
fasteners. Remove front portion of driver’s side wheel
well, held on by four screws.
4. On passenger side, loosen front portion of wheel well
extension, two plastic push fasteners, and remove ap-
proximately four more plastic push fasteners from inside
of wheel well. This is done to gain access to nuts holding
facia.
5. Remove two nuts holding facia to fender on each side
by going through wheel well opening.
6. Remove two plastic push fasteners from bottom side
of bumper and unplug fog light.
8. Bend horn bracket to clear base plate when in-
stalled.
7. Pull facia down on each side by fender and carefully
pull facia off.