Dometic Eskimo Ice Remote Ice Crushing System User Manual
Eskimo ice
Table of contents
Document Outline
- Introduction
- Drawings and Diagrams
- Ice Making and Refrigeration Basics 3
- Ice Maker Components
- Installation
- Choosing the Correct Voltage Equipment
- Installing the Condensing Unit 5
- Selecting the Site
- Site Location Check List
- Mounting the Condensing Unit
- Installing the Auger Unit
- Site Location Check List
- Mounting the Auger Unit
- Installing the Ice Level Sensor
- Installing Ice Delivery Hose
- Installing the Refrigerant Linesets 6
- Connecting the Quick Connect Fittings
- Installing the Feed Water System
- Water Quality
- Use of Saltwater as the Evaporator
- Installing the Seawater Cooling System 7
- Through-Hull Inlet Fitting
- Seacock
- Strainer
- Seawater Pump
- Required Seawater Flow Rate
- Manifolds
- Overboard Discharge
- Seawater Piping
- Bonding
- Pump Relay
- Installing the Control Panel
- OPERATION
- Start-up Check List
- Servicing the System
- Refrigerant
- R134a Tools
- Constant Pressure Valve (CPV)
- Quick Connect Fittings (QC)
- Recharging the System
- System shutdown
- Evacuate Refrigerant
- Charging the System
- Setting the Constant Pressure Valve (CPV)
- Constant Pressure Valve (CPV) Replacement
- Maintenance
- Seawater System
- Refrigerant Gas
- Compressor
- Auger Motor
- Auger Gearbox
- Water Reservoir
- Water Filter
- Evaporator Cleaning
- Winterizing the System
- Troubleshooting Guide
- Limited Warranty Periods
- Description of Figures and Diagrams