DeWalt DWD010 - Manual (Page 8)

7
English
KEYED CHUCK INSTALLATION (FIG. 4)
Screw the chuck on by hand as far as it will go. Insert the shorter
end of a hex key and strike it in the clockwise direction with a soft
hammer.
MAINTENANCE
Your D E WALT power tool has been designed to operate over a
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and removing
accessories, before making any adjustments or removing/installing
attachments or accessories.
Motor Brushes
D E WALT uses an advanced brush system which automatically stops
the drill when the brushes wear out. This prevents serious damage
to the motor. New brush assemblies are available at authorized
D
E WALT service centers. Always use identical replacement parts.
Lubrication
Self-lubricating bearings are used in the tool and periodic
relubrication is not required. In the unlikely event that service is ever
needed, take your tool to an authorized service location.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry
air as often as dirt is seen collecting in and around the air vents.
Wear approved eye protection and approved dust mask when
performing this procedure.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered by
D E WALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
E WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
CAUTION: To reduce the risk of injury, the following accessories
should be used only in sizes up to the maximums shown in the table
below.
MAXIMUM RECOMMENDED CAPACITIES
DWD010 DWD014
CHUCK CAPACITY 6.5 mm 10 mm
BITS, METAL DRILLING 6.5 mm 10 mm
WOOD, FLAT BORING 15 mm 25 mm
SPECIFICATIONS
DWD010-B3 DWD014-B3
Voltage 120 V~ 120 V~
Frequency 50-60 Hz 50-60 Hz
Power - watts 380 W 600 W
RPM 0–3600 0–2800