Avanti 248RW/RC/RB - Manual (Page 3)

INSTALLATION
• Place your appliance on a floor strong enough to support it nhen fully
loaded.
• This appliance is designed for free standing only and should not be
recessed or built-in.
• Let air circulate freely around appliance. Keep rear 4 inches away from
wall and at least 5 inches space on sides.
• The location yon choose should be away from heat sources like stove,
heater or radiator.
• Avoid installing your appliance in humid places (like next to sinks).
SETTING THE TEMPERATURE CONTROL
The temperature control dial has settings from thewarmest(l)to the coldest (
6
)
M clockwise ,plus“OFF'’.
Initially set the dial to the center position. After using the refrigerator for a
full day, adjust the dial to the setting that is best suited to your needs. Turning
the control to thr^OFF” stops the cooling cycle You must allow at least 3
minutes before starting it again.
DEFROSTING
Defrost whenever frost on the wall of the ice tray compartment becomes
1/4 inch thick. Remove food and ice tray and set temperature control dial to
"OFF".
Never use any sharp or metallic instrument to remove ice/frost as it may
damage the cooling coils. We recommend using a plastic scraper.
When defrosting is completed,remove drip tray and empty water from the drip
tray. Then turn temperature dial to desired setting and return food and ice
tray to the refrigerator.
Defrosting usually takes a few hours. To defrost faster, keep the door open.
Also, pouring warm water on the frosted part will help. Do not use boiling
water as it may damage plastic parts.
USE OF THE ICE CUBE TRAYS
For your ice requirements, fill approximately 3/4 of the tray after washing it
To release the ice cubes,hold the tray upside down and twist shghtlg at both