AEG KF 1064 - Manual (Page 9)

The length of time the coffee takes to brew is varied by means of the aroma switch.
Setting a small number of cups results in a longer brewing time, so that the water
remains in contact with the ground coffee for longer and the aromatic ingredients in it
are dissolved better.
- KF1050: Press the aroma switch once (Fig. 2/C), and the indicator will appear for
“min -4“ as the number of cups (Fig. 2/E). This switch setting will guarantee you
the full coffee aroma when you make up to four cups.
Press the aroma switch again (Fig. 2/C) and the indicator for “min -4” will vanish
from the display (Fig. 2/E). This is the correct setting for making two to ten cups.
- KF1064 and KF1066 Black Line: The aroma switch (Fig. 2/C) guarantees you
the full aroma regardless of the number of cups you make.
You can select whether you wish to make up to 2, up to 4, up to 6, or up to 10 cups
of coffee.
When you plug your coffee-maker in to the mains, the aroma level “Up to 10 cups”
will be selected because it is pre-set in the factory. The “10” will light up in the
indicator for the number of cups (Fig. 2/E).
By pressing, however, you can determine the number of cups to be made. Each
time you press the aroma switch (Fig. 2/C), the indicator for the number of cups
(Fig. 2/E) will move one step at a time downwards, starting with “10”.
When the appliance is next switched on again, the figure for the number of cups
will automatically appear which was selected last time.
6. Switching the appliance on
Flaving selected the number of cups, switch the appliance on by means of the
“01” button (Fig. 2/A). The pilot light (Fig. 2/B) will come on. After a few seconds,
hot water starts to flow into the filter.
Selecting the warming temperature (only KF 1064 and KF 1066 Black Line)
In addition to the aroma function,, your automatic coffee-maker provides every possi­
bility for you to set it individually to suit your habits.
When you press the aroma switch (Fig. 2/C), the middle level^^ “2”, will appear
(Fig. 2/0) because it is pre-set in the factory. By pressing the “ip” button for the
warming level (Fig 2/N), however, you can pre-select a lower warming temperature
independently of this, at Level 1, or a high temperature at Level 3. The warming level
selected will appear in the display (Fig. 2/0).
When the appliance is next switched on again, the figure for the warming level will
automatically appear which was selected last time.
Initial brewing phase (only KF 1064 and KF 1066 Black Line)
Your coffe-makers has a function called an initial brewing phase to ensure the
maximum coffee aroma.
After the first small quantity of water has dampened the ground coffee in the filter, the
coffee-making cycle is then interrupted for a short time.
During this time, the ground coffee soaks up the water, thus enabling it to develop
its full aroma.
The result is the maximum coffee aroma.
15