AEG KF 1064 - Manual (Page 11)

If you wish to use the appliance in the normal mode of operation again, press the
“auto” button once again and the “auto” lettering in the display will disappear.
You can also switch the appliance on directly with the “01” button (Fig. 2/A). The
lettering “auto” will then disappear from the display and the operational mode
indicator (Fig. 2/B) will light up.
Cleaning
The swivelling filter can betaken out for cleaning (Fig. 9). Swing itouttothe right as far
as it will go. It can then be lifted oulToclean the filtervalve thoroughly, please actuate
it several times while washing it up. To fit the swivelling filter back into place, hook it
on to the hinge jointfrom above and swing it in to the left. Clean the appliance all over
with a damp cloth - but never immerse it in water!
The coffee jug and its lid are safe in a dish-washing machine.
De-scaling
... SO that your coffee-maker will continue to serve you for many years
The service life of your coffee-maker will be longer if you de-scale it regularly. If you
use a gold filter, this must be taken out of the swivelling filter before de-scaling starts.
An environmentally friendly de-scaling agent should be used, such as is widely
available in the trade. Only ever use it in accordance with the manufacturer’s instruc­
tions. You first fill the fresh-water tank with water, and then you add the de-scaling
agent to it. Then, swing the swivelling filter back into the appliance and place the
coffee jug, with its lid, on the warming plate. (Please note that the jug lid has the job of
opening the filter valve, so a cycle can only run properly if it is in place.) Leave the
solution for 15 minutes to work in.
- KF1050: Now switch the appliance on by means of the “Ol” button (Fig. 2/A)
and let the water and de-scaling agent run through.
- KF 1064 and KF 1066 Black Line: These appliances are equipped with a
de-scaling programme, which can be started at any time if the appliance is
switched off.
If de-scaling is necessary, the de-scaling display (Fig. 2/P) will start to flash.
It does not stop flashing until the appliance has been sufficiently de-scaled.
Fill the fresh-water tank with water and de-scaling agent as described above, and
then activate the de-scaling programme by pressing the “signal” button (Fig. 2/L)
and the button for pre-selecting the warming level (Fig. 2/N) both atthe same time
and holding them down for about 3 seconds. The de-scaling indicator in the
display now comes on and stays on, and the pilot light (Fig. 2/B) comes on to
show that the de-scaling programme has started. The water and de-scaling
agent will now remain in the through-flow heater for some minutes. This in­
creases its cleaning effect. Once the de-scaling cycle has finished, the appliance
will switch itself off again. If the fresh-water tank has been filled to its maximum
level, the de-scaling cycle will take about 60 minutes.
17