Evaporator drip tray, Changing the light bulb, Care and maintenance – Avanti 309YBT User Manual
Page 11: Cleaning your appliance, Operating your appliance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^ Evaporator Drip Tray
• The drip tray is located on the top of the compressor in the rear of the unit It can be
easily removed by pulling the handle forward. When placing it on drip, tray hole insert it
horizontally as shown below.
• If not properly installed, defrosted water can enter into the compressor causing dam
age.
Hole
> CHANGING THE LIGHT BULB
Before rerroving the light buto, either unplug the refrigerator or disconnect the electricity
leading into the refrigerator at thfe main power supply. Failure to do so could result in
electrical shock or personal injury.
• Take the Hems off the shelf and remove the shelf. There is an opening in the bottom of
the thermostat control in the back.
• Reach into the hole and unscrew the bulb.
• Replace wth a 15 watt - refrigerator bulb that is the same shape and size.
• Replace the shelf and any Hems you may have previously removed.
CARE AND MAINTENANCE
^ Cleaning Your Appliance
• Turn the temperature control to“OFF”, unplug the appliance, and remove the food,
shelves, and trays.
• Wash the inside with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
• Wash the shelves and trays wHh a mild detergent solution.
• The outside of the appliance should be cleaned with mild detergent and warm water.