Avanti WD360 - Manual (Page 8)

Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on
opening of bottle while placing in reservoir.
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
Wipe off any water which may have splashed on dispenser top.
Cold Water Control
Turn on the power switch at the back of the unit. The amber (cool) indicator will be lit and the
process begins. When the water reaches the right temperature the amber (cool) light goes off and
the green (cold) light turns on.
Cup Dispenser (Optional)
A cup dispenser may be installed by using the mounting holes (covered with plastic caps) located
near the top of the right side panel of the cooler. The cup dispenser comes equipped with a
mounting bracket and screws and may be ordered by completing the enclosed order form
provided with your instruction manual.
CARE AND MAINTENANCE
• Wash the inside of the reservoir with a warm water and baking soda solution. The solution
should be about 2 tablespoons of baking soda to a quart of water.
• The drip tray and water faucets should be cleaned with mild detergent and warm water.
• At regular intervals or once a month inspect the coils located across the back of the dispenser.
Vacuum accumulation of dust or clean it with a hard brush.
TAKING DISPENSER OUT OF SERVICE
• If the water dispenser will not be used for a long period of time, unplug the power cord from
the wall outlet.
• Drain the water through the faucets.
• Drain the water from the tanks by removing the plug from the water drain on the back of the
dispenser.
• Unit should not be transported on the sides. Place it upright if possible and cover if with a
blanket.
PROBLEMS WITH YOUR WATER DISPENSER?
You can solve many common water dispenser problems easily, saving you the cost of a
possible service call. Try the suggestions outlined below to see if you can solve the
problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE
Water dispenser does not operate. Not plugged in.
The circuit breaker tripped or a blown fuse.
Water cooler is not cold enough. The water dispenser does not have the correct
clearances.
Compressor turns on and off frequently. The room temperature is hotter than normal.
The temperature control is not set correctly.
The water dispenser does not have the correct
clearances.
Vibrations. Check to assure that the water dispenser is
level.