Operating your water dispenser – Avanti WD360 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
r ‘
•
Fill water tank with tap water full to capacity (more than 3/4 of a gallon). Wait for 5
minutes until water settles.
•
Press the room temperature water faucet until water comes out, then stop.
•
Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In
order to do that, wait for approximately 40 minutes for the cold water to reach its
designed temperature.
•
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the
faucets one at a time until no more water remains.
(Note; To facilitate this operation, use a large container).
•
Then, drain any water left in the tanks by opening both water faucets until it drains
completely.
•
Place the 3-5 gallon bottle of water on the water intake, allow water to stand for
approximately one minute.
•
Turn on water faucets to insure water flows from both faucets.
•
Plug dispenser back into the electrical outlet.
•
Now you are ready to use your water dispenser.
NOTE:
Your water dispenser has been cleaned and sanitized before leaving the factory, but
in case a taste problem develops, place one tablespoon of baking soda and add tap water. Fill
water tank again and repeat basic operations previously outlined.
yWARNINOy
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. !F
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.
OPERATING YOUR WATER DISPENSER
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize
the possibility of electrical shock.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord.
Any
questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
This appliance requires a standard 115/120-volt, 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
OPERATING YOUR WATER DISPENSER
Steps to replace water bottles
•
Use a clean cloth to wipe off neck of bottle.
•
Remove cap.