Autostart AS-1221 User Manual
Autostart Car alarm
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To obtain a copy of the installation guide,
click on the « Download e tab.
and
Installation Guide
A U T O M A T I C T R A N S M I S S I O N R E M O T E S T A R T E R
AS-1221/AS-1222
Quick Installation Guide
To obtain a copy of the installation guide,
please visit the
click on the « Download e tab.
Table of Contents
How to Flash the Hood Pin............................ 1
Resetting the Module (without the plug-in
valet)................................................................2
Transmitter Programming Procedure............. 2
Entering Programming Options...................... 2
Programming Options.....................................2
Tach Programming..........................................3
Tach jumper settings.......................................3
Supplementary Information.............................6
Fifth Relay Output (2nd IGN, ACC or
CRANK)...........................................................6
Testing.............................................................6
Diagnostics - Parking Light Flash Table.......... 7
Please note:
Button I
is
for
START (by
default).
Button II
is
for
STOP (by
default).
Buttons I & II (together) is for the
trunk
release function.
The LED is NOT included in this model.
The valet button is optional.
How to Flash the Hood Pin
THE INSTALLER >
THE MODULE >
1. Press and hold the hood pin for 4 seconds.
2. Release the hood pin.
3. While the parking lights are on, press down the hood pin once more
and release the hood pin immediately.
4. You now have 20 seconds to select one of the sub-menus
Parking Lights “ON”
“ON” for 20 seconds
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be
that either damage to the vehicle itself or to the unit. This unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart technicians: a certain level of skills and
knowledge is therefore assumed. Please review the installation guide carefully before beginning any work.
Warning
This remote starter is designed for vehicles with an
automatic transmission only. Before installing the unit, test that the
vehicle does not start when the gear select lever is in the “Drive” position. If it starts in gear, install a manual-transmission
remote starter system instead.
DOC.4.01
- October 20, 2006
CA SP
Manufactured in Canada
P. 8