Before using your appliance, Installation instructions – Avanti W851 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
Remove the exterior and interior packing.
Check to be sure you have all of the following parts;
• Hot Water Supply Hose
• Cold Water Supply Hose
• Drain Hose (Pump)
• Instruction Manual
• Absorbing Panel & Screw
• Male and Female Hose Thread Adapters
• Support Legs
Clean the interior surface with lukewarm water using a soft cloth.
Place your washer on a floor that is strong enough to support the appliance when it is fully
loaded.
To level your washer, adjust the legs at the front of the appliance.
Allow 5 inches of space between the back and sides of the appliance.
Carpeting must not obstruct ventilation openings when the washing machine is installed on
a carpeted floor.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating, plastic and electrical components.
Put your laundry into the washer evenly. Uneven laundry may cause noise or vibration.
Don’t use excessively hot water 50°C(122'F) or more. Plastic parts may be deformed or damaged.
Also, clothing may be deformed or bleached.
Before washing, check all pockets. If nails or pins remain in pockets, they may damage the
washer or clothes.
Never splash water on the control panel.
Plug the washer into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
©