Defrosting, Use of the ice cube trays, Figure 2 defrosting – Avanti 863 YW User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USE OF THE ICE CUBE TRAYS
An ice box is supplied together with an ice tray. For your ice requirements, fill approximately 3/4
of the fray after having washed it.
To eject ice cubes into the bucket provided, insert the ice tray and twist slightly until the pieces
of ice fall.
If cubes are not used, they may shrink. The longer cubes are stored, the smaller they get.
FIGURE 2
DEFROSTING
■■ '^rV :
For the most efficient operation and mininum energy consumption, defrost freezer compartment
when there is excessive frost on the wail of the freezer section (or reaches a quarter inch
thick). If defrosting is not done for a long period of time (longer than 2 weeks) and the ice layer
on the freezer wall reaches over a quarter inch (1/4) thick, remove food stored in freezer
compartment and keep door open in order to defrost faster.
To start defrosting, push button at the center of the
temperature control knob. The compressor will stop running
and will automatically re-start once ice is melted.
During the defrost operation, you may let the water fall into a
pot (see the sketch) by pulling the red discharge tab under
the defrost pan. In this case, you do not have to remove the
water collection tray.(Figure 3)
After the defrost operation, clean the water in the water
collecting tray.
FIGURE