Avanti WD31 - Manual (Page 9)

• Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction In the cooling
system from handling during transportation.
• The water dispenser is pre-deaned at the factory but the reservoir and water lines
must be flushed with fresh water before use as follows:
• Keep the unit unplugged.
• Fill water tank with tap water full to capacity (almost 3/4 of a gallon). Wait for 5
minutes until water settles.
• Press both room temperature and cold-water faucets until water comes out, then
stop.
• Plug the dispenser into the electrical outlet. We are ready to complete the first
cycle. In order to do that, wait for the cold water thermostat to cut-off and the
compressor stop working (approximately 40 minutes for first cycle),
• Place the 5-galIon bottle of water on the water intake, allow water to stand for
approximately one minute.
• Turn on water faucets to insure water flows from both faucets.
• Plug dispenser into the electrical outlet.
• Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the
factory, but in case a taste problem develops, place one tablespoon of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined.
yWARNINOy
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.
OPERATING YOUR WATER DISPENSER
> Steps to replace water bottles
• Use a clean cloth to wipe off neck of bottle.
• Remove cap.
• Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands in
opening of bottle while placing in reservoir.
• Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
• Wipe off any water which may have splashed on dispenser top.
> Cold Water Control
Once the unit is plugged into power supply outlet, compressor will start working and the cooling cycle
begins. When the water reaches the right temperature the cooling thermostat will cut-off automatically
and compressor will stop working.
> Cold Water Faucet
This faucet (blue finish) provides cold water.
> Room Temperature Faucet
This faucet (white finish) provides room temperature water.
> Cup Dispenser (Optional)
A cup dispenser may be installed by using the mounting holes (covered with plastic caps) located
near the top of the right side panel of the cooler. The cup dispenser comes equipped with a mounting