Start/pause – AEG 1370-1 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

START/PAUSE

■ Start/Pause

After the machine has been switched on, the pilot light over this

button starts to flash.

When the button is pressed, the programme starts and the pilot

light goes out.

To interrupt the programme or to open the porthole door in the

middle of a programme, press this button again. The pilot light will
start to flash.

The door can only be opened after about 2 minutes.

When the button Impressed again, the programme resumes and
the light goes out.

Important:

The door can only be opened if the water level is

lower than the bottom of the porthole. Otherwise, the water must

first be pumped out.

The START/PAUSE button can also be used to pump out the

water after the SOAK programme and after a RINSE HOLD pro

gramme: the soaking water is only pumped out, whilst in the other
programmes the machine will perform a short spin.