Avanti WC500CL - Manual (Page 8)

> Temperature Contr&l
• The first time you turn the unit on, set the temperature control to "MAX” position.
• The settings of the temperature control are “OFF’, "MIN”, “NORMAL” and “MAX". After 20
minutes, adjust the temperature control setting to “NORMAL". The setting of “NORMAL"
should be correct for home or office wine cooler use.
• To turn the wine cooler off, turn the temperature control to "OFF’.
NOTE:
■ Turning the temperature control to “OFF position stops the cooling cycle, but does not
shut off the power to the wine cooler.
■ If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit, if you attempt to restart before this time delay, the wine cooler will not
start.
■ The range between “MAX” and “MIN" is from 45° F to 65° F, which is ideal for the storage
of wines.
It is recommended you install the wine cooler in a place where the ambient temperature is between
72-78 degrees Fahrenheit. If the ambient temperature is above or below recommended temperatures,
the performance of the unit may be affected. For example, placing you unit in extreme cold or hot
conditions may cause interior temperatures to fluctuate. The range of 45-65 degrees Fahrenheit may
not be reached.
If the interior light is left on, the temperature inside the wine cooler will be higher.
Recommended Temperatures For ChiHina Wine
OPERATING YOUR WINE COOLER
Degrees Control Position
Red Wines: 59-65° F Min
DryAA/hite Wines 49-56“ F Normal
Sparkling Wines 45-49“ F Max
Rose Wines 49-51“ F
1
Normal
Temperature Range Guide
MIN 59-65°F -
MED 50-56°F
MAX 45-50°F
The above temperatures may fluctuate depending on whether or not the interior bulb is on or off or
whether the bottles are located on the upper/middle or lower section.
CARE AND MAINTENANCE
\
> CHANGING THE LIGHT BULB
NOTE:
All parts removed must be saved to do the replacement of the light bulb.
Before removing the light bulb, either unplug the refrigerator or disconnect the electricity
leading into the refrigerator at the main power supply. Failure to do so could result In
electrical shock or personal injury.
» Move the light switch {4} to the “OFF position.
" Remove the light bulb cover (1) by pulling the bottom end of the light bulb cover gently.
■ Unscrew the bulb (2).