Warning, Reversing the door swing of your wine cooler – Avanti WC500CL User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

tsâ(3ykitîiZj;jy.iùi6^^

/^^Warning/^

Improper use of the grounded plug can result in the risk of electrical shock, if the power

cord is damaged, have it replaced by an authorized Avanti Products service center.

> Reversing the Door Swing of Your Wine Cooler

This wine cooler has the capability of either opening the door from the left or right side. The unit is

delivered to you with the door opening from the left side. Should you desire to reverse the
opening direction, please follow these instructions.

NOTE:

All parts removed must be saved to do the re installation of the door.

•

Remove the two back plugs (11) and two front plugs (12) located in the top cover.

•

Remove the four screws (10) holding the top cover(9).Place the top cover(9) on a padded

surface to prevent scratching it.

•

Remove the upper right hinge (7), holding the door in place.

•

Lift the door and place it on a padded surface to prevent scratching it.

•

Lay the unit on its back against a solid surface at an angle of no less than 45 degrees.

•

Remove the upper hinge pin (8) from the hinge (7).

•

Replace the right upper hinge (7) to its original location.

•

Remove the two bolts (2) that hold the lower right hinge (5).

•

Remove the front leg (3) and the lower hinge pin (4) from the lower hinge (5).

•

Save the lower hinge assembly for later use.

•

Remove the lower left hinge (l)-and transfer it to the opposite side, reversing the direction
180 degrees, where the lower right hinge (5) was previously located.

•

Transfer the lower hinge previously removed to opposite side, where the left lower hinge (1)

was located, reversing the direction 180 degrees. Then insert the front leg (3), the two
bolts and the pin(4).

•

While holding the door in the closed position, secure the lower hinge on the left side of the

frame, by screwing the bolts (2) in. Do not tighten until door is level.

•

Remove the upper left hinge (6) and Insert the upper hinge pin (8).

•

Replace the upper left hinge (6) with pin (8) to secure the door.

•

Place the top cover by inserting all four screws previously removed in step 2.

•

Insert all the plugs previously removed in step 1.

Position prior to door reversal Position after to door reversal

® Upper right hinge

® Front leg

® Screw