Disarming, Disarming without a transmitter – Directed Electronics 3901V User Manual

Page 9

Disarming

To disarm the system, unlock the doors using your factory keyless trans-

mitter. The siren will sound twice, and the parking lights will flash twice.

If the siren sounds either four or five times when disarming, refer to the

Diagnostics section of this guide. This is called Tamper Alert.

Disarming without a transmitter

This feature allows you to override the system without the transmitter

should it be lost, damaged or disabled. To do this, you must have the ve-

hicle's ignition key and know where the integrated LED/Valet

switch is

located. The Valet

switch is activated by pressing the LED status indicator.

Turn the ignition to the “run”position.

Press and release the integrated

LED/Valet

switch, within 10 seconds.

After a few seconds the LED will stop

flashing and the vehicle should start. If it does not, you may have waited

too long. Turn the ignition off and try again.

nnoottee:: The setting for the number of times the integrated
LED/Valet® switch must be pressed is set in the
Programming Section of this guide.

DRW-35

Integrated

LED/Valet

switch

LED status indicator