Valet, Mode, Panic mode – Directed Electronics 3901V User Manual

Page 10

Valet

mode

You can prevent your system from arming, by using Valet

Mode. This

is very useful when washing the vehicle or having it serviced. In Valet

Mode, the system will not arm, even with the transmitter, but all con-

venience functions (door locks, trunk release, etc.) will work normally.

To enter or exit Valet® Mode with the integrated LED/Valet® switch:

Turn the ignition to “on” position,

then turn to “off” position. Press

and release the integrated

LED/Valet

switch within 10 sec-

onds. The status LED will light

steady if you have entered Valet

Mode. To exit Valet

Mode, repeat the

steps above. The LED will turn off when exiting Valet

Mode.

Panic mode

(If programmed On, Step 3-2)

If you are threatened in or near your vehicle, you can attract attention

by triggering the system with your transmitter! If your factory keyless

transmitter does not have a panic button, this system can be pro-

grammed to enable a panic feature (refer to the Programming

Options).

If enabled, just press the lock button on your factory keyless transmit-

ter twice more than once within three seconds 7 seconds to enter Panic

Mode.

DRW-35