Using homelink, Reprogramming a single homelink button, Security – Dodge 2009 Ram 1500 User Manual
Page 160: Troubleshooting tips, Reprogramming a single homelink, Button
Using HomeLink
ா
To operate, simply press and release the programmed
HomeLink
button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.) The hand-held transmitter of the device may also be
used at any time.
Reprogramming A Single HomeLink
ா Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink
button for
20 seconds until the indicator(s) starts to flash. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming Homelink
, Step #2, and follow all remaining steps.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the indicators begin to flash. Note that
all channels will be erased. Individual channels cannot be
erased.
The HomeLink
Universal Transceiver is disabled when
the Vehicle Theft Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink
, here
are some of the most common solutions:
• Replace the battery in the original transmitter.
• Press the “Learn” button on the garage door opener to
complete the training for Rolling Code.
158
UNDERSTANDING THE FEATURES OF YOUR VEHICLE