Programming homelink – Dodge 2009 Ram 1500 User Manual
Page 156
WARNING!
• Your motorized door or gate will open and close
while you are training the Universal Transceiver.
Do not train the transceiver if people or pets are in
the path of the door or gate. Only use this trans-
ceiver with a garage door opener that has a “stop
and reverse” feature as required by federal safety
standards. This includes most garage door opener
models manufactured after 1982. Do not use a
garage door opener without these safety features.
Call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for safety information or as-
sistance.
• Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming HomeLink
ா
Before You Begin
The Compass Mini-Trip Computer (CMTC) illuminates
the HomeLink
symbol (a house with an arrow inside it)
along with 1, 2 or 3 indicators under it, when a
HomeLink
button is pressed.
Pay attention to the indicator(s), as they will flash at
different rates, or remain solid during training.
If you have not trained any of the HomeLink
buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for
20 seconds. Release the buttons when the indicators start
to flash.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink
for more efficient training and accurate
transmission of the radio-frequency signal.
154
UNDERSTANDING THE FEATURES OF YOUR VEHICLE