Adcom GCD-200 - Manual (Page 9)

WIRELESS REMOTE CONTROL [
MODEL gcd-300 only |
Corresponding operation buttons on the gcd-300 player
and the remote controller perform the same functions.
Operation can be performed with either this unit or the
remote control.
NOTE: '
This unit is for use only with the compact disc
player gcd-300. It cannot be used with other
components (cassette tape deck, etc.)
V________ ________________________________________ __________________ ✓
■ Program number buttons
Use the Program number buttons @) only when speci­
fying a track number.
(You cannot specify an index number using the pro­
gram number buttons.)
• Specifying the track number while the unit is in
the stop mode
1. Specify the desired track number using the Program
number buttons (^. The specified track number will
flash in the Digital display (Q).
[To change the track number (or if you pressed the
wrong track number), specify the correct track
number while the indicator is flashing.]
2. By pressing the Play/Pause button (^, the disc will
be played from the specified track.
• Specifying a track during play
1. Specify the desired track by pressing the program
number buttons
[The track number/index number (or time) for the
track being played will remain on the digital display
(0), the specified track number will not appear.]
2. By pressing the Play/Pause button (5), play will com­
mence from the specified track number.
NOTE: '
A track number which is not on the disc can't be
selected.
*
■ Loading batteries
(T] To remove the battery compartment lid, press
down on it while sliding as shown in the figure
below.
[2] Insert batteries with their @ Q polarities cor­
rectly matched to the diagram inside the battery
compartment.
(3] Replace the battery compartment lid, sliding it on
until it locks into place with a "click".
If the batteries are used incorrectly, there is a
danger of the internal fluid leaking or the bat­
teries bursting.
Do not use new and old batteries together.
Do not use different kinds of batteries together.
Batteries consist of rechargeable and nonrecharge-
able types. Verify the type of battery by reading the
caution label on the battery.
If you are not going to use the remote control unit for
a long period, remove the batteries.
Do not heat, disassemble, or short circuit dry bat­
teries, or throw them into a fire.
MAINTENANCE
■ Treat disc surfaces carefully
Handle the discs so that fingerprints and dust do not
adhere to the surfaces of the discs. To clean-off, use a
soft cloth. Do not use a rough cloth since this will mark
the disc.
■ Clean cabinet and panels when dirty
Clean off dirt on the surfaces with a dry cloth. Never
use thinners, benzene or alcohol since these will
damage the surface finish.