Trouble shooting, Precautions for use – Adcom GCD-200 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLE SHOOTING
Trouble
Cause
Remedy
Power is turned on, but indicators do
not light.
1. Power plug is not connected securely.
1. Insert the power plug into the power outlet
securely.
Drawer Open/Close button is
pressed, but Drawer does not open.
1. Open signal is not received correctly.
1. Press the Drawer Open/Close button again
and confirm the Open/Close indicator is
flashing.
Disc is loaded, but total number of
programs is not displayed.
1. Disc is loaded upside down.
2. Disc is dirty.
3. Disc used is nonstandard.
1. Load the disc correctly.
2. Clean the surface of the disc.
3. Replace the disc.
Play/Pause buttonf^/M) is
pressed, but play does not begin.
1. Disc is dirty.
2. Disc has scratches or is warped.
1. Clean surface of disc.
2. Replace disc.
No sound is produced.
1. Connector pin-cords are not connected.
1. Connect the connector pin-cord to the output
terminals of the player and the input
terminals of the amplifier.
Sound is distorted.
1. Connections to amplifier are wrong.
2. Amplifier output is set too high and sound is
being clipped.
1. Connect player to amplifier correctly.
2. Turn down the amplifier output volume.
A particular spot on the disc does
not play correctly (sound cuts out. or
same spot is repeated).
1. Disc has scratch or Other damage.
2. Disc is dirty.
1. Use the Fast forward/Index button to pass
over the part scratched.
2. Clean the surface of the disc.
digital
AUOtO
PRECAUTIONS FOR USE
•
Discs which can be played on this _n
compact
player have the following mark on
them
• During playback,
if
the player is subjected to a sud
den shock or jolt, some noise may be produced.
This is
not a malfunction.
• If the player is operated while you are receiving an
FM/AM radio broadcast, you may hear noise on the
radio broadcast. In this case, turn the CD player's
power switch off.
• If other audio components or their connecting cords
are installed near this player, you may hear a hum
ming sound. In this event, try changing the location
of the other components or their wiring.
• Whenever moving the player, be sure to first remove
the disc from it. if the player is moved with a disc
loaded, the disc may be damaged.
• The gcd-200/gcd-300 has a wide dynamic range. As
a result, if you turn your amplifier's volume up too
high during soft (low volume) parts of a program,
your speakers may be damaged when the dynamic
range of a sudden loud passage is produced.
Do not move the player suddenly from a very cold
room into a warm room. When a chilled player is
moved suddenly to a warm location, moisture con
densation may form on the pickup lens, preventing
proper operation. In this case, wait 30 minutes
before resuming play.
Do not place foreign objects in the disc drawer and
attempt to operate the drawer control (Open/Close)
function. It may cause damage to the mechanism.
Do not store discs in high-temperature, high-
humidity locations. The discs may develop warps
and become unplayable. Also, discs with moisture
on them may be unplayable. Wipe any moisture off
with a soft, dry cloth, and be sure discs are fully dry
before using.
If the unit is installed in a confined location, heat
dissipation will be poor and malfunctions may
occur. Also, do not install the unit on top of
amplifiers or other components liable to become hot.
11