Electrical connection, Spacers installation, Mobile home installation – Avanti GR-24BG User Manual
Page 9: Figure 6, Operating your gas range
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Electrical Connection
•
Electrica! connection must be made in accordance with local codes or in absence of
local codes, with the National Electrical Code, ANSlINFPA No.70-Latest Edition.
•
Connect the 2-prong supply cord to a 120-volt, 60 Hz, 2-prong wall receptacle.
• Electrical connection must not interfere with gas connection.
Warning
Improper use of the grounded plug can result in a risk of electrical shock. If the power
cord is damaged have it replaced by an authorized Avanti Products Service Center.
> Spacers Installation:
In order to keep the range away from the back wall at a distance of 6”: install the
spacers as seen in Figure 5 before installation of the range. Screw the spacers to the
end of the screws located on the bottom rear, then install the range.
> Mobile Home Installation
The
Installation
of
this
range
must
conform
with
the
Manufactured
Home
construction
and
Safety
Standard,
Title
24
CFR,
Part
3280
{formerly
the
Federal
Standard
for
Mobile
Home
Construction and Safety, Title 24, HUD (Part 280)} or, when such standard is not applicable, the
Standard
for
Manufactured
Home
Installations.
ANSI
A
225.1
and
Manufactured
Home
Installations, Sites, and Communities ANSI/NFPA 501 A, or with local codes.
When this range is installed in a mobile home, it must be secured to the floor during transit. Any
method of securing the range is adequate as long as it conforms to the standards listed above.
Copies of the standards may be obtained from:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
American Gas Association
1515 Wilson Bivd.
Arlington, VA 22209
OPERATING YOUR GAS RANGE
Before
operating
the
unit,
read
this
section
thoroughly.
The first time the burners are used, a small amount of
smoke may be generated due to burning of grease on the
burners, especially on oven and broiler burners. This is not
dangerous. For that reason, the burners must be operated
without any cooking purpose for 10 minutes for the first
time.
This
range
is
equipped
with
an
electric
ignition
system
to
ignite
the
burners.
Therefore,
it
must
be
supplied
with
electricity.
If
any
electric
power
failure
occurs, using a match can ignite the burners. A constant
supply
of
air
is
needed
for
combustion.
Therefore,
allow
sufficient, ventilation into _the_room_whefe_the_range_is-
piaced.
Figure 6