Dimplex SP420 - Manual (Page 6)

The front surround will need to be removed in order to change
lamps.
Warning -The front surround is heavy and easily damaged !.
The front surround is fixed with 4 spring loaded pins and is
supported at the top by the chassis.
To gain access to the lamps please apply the following proce-
dure:
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE REMOVING LAMPS.
Lamp Replacement
Fig. 10
Fig. 11
While holding the surround by its sides with both hands, care-
fully pull forwards the surround at the bottom until the pins
detach from the clips (see Fig. 9).
When the bottom holding pins are undone, carefully pull for-
wards at the top until the top pins detach and then lift the
surround up and out (see Fig. 10).
For access to the bottom bulbs, carefully slide the flexible ro-
tisserie to one side ensuring that the rubber grommets are
not lost (see Fig 11).
Remove the defective lamp by unscrewing it (see Fig 12).
Replace with a 60W E14 SES clear candle bulb, rotating it.
Take care not to over tighten the bulb.
To refit the surround back to the chassis:
1. Refit the rotisserie making sure that the rubber grom-
mets are carefully pushed back into the slotted holes on the
axial brackets (see Fig 11).
2.
Place the surround on the chassis bracket and align
the pins with the spring slots. Make sure the surround is the
correct way up with the cut out for switches at the bottom (see
Fig 10).
3.
Push firmly at each corner of the surround where the
pin is located until it clips back into position.
Spring clip
Holding Pin
Spring clip Holding
Pin
Chassis
bracket
Chassis
Grommet
Rotate flexible
Rotisserie out of
position
Flexible Rotisserie
rotated out of position
Fig. 12
Fig. 9