Dell PowerEdge 2420 - Manual (Page 15)

Installation Guide
13
3 Reverse the top hinge body.
a Pull the hinge pin upward slightly so that you can access the retention
clip (see Figure 1-5).
Figure 1-5. Removing the Front-Door Hinges
b Using the needle-nose pliers, remove the retention clip, and then slide
the hinge pin out of the hinge body.
c Remove the hinge spring from the hinge body.
d Place the hinge pin, retention clip, and spring in a safe location.
e Using the 4-mm Allen wrench, remove the Allen bolts that secure
the hinge body to the rack, and place the bolts with the hinge pin,
retention clip, and body spring.
f Rotate the hinge body 180 degrees so that the hinge-pin holes are now
on the right side of the hinge body (see Figure 1-6).
1 hinge post 2 top hinge body
3 bottom hinge 4 hinge pin
5 retention clip 6 body spring
4
3
2
5
6
1