Searching for your code learning a function, Caution, Deleting a learned function – Arcam CR80 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEARCHING FOR YOUR CODE
LEARNING A FUNCTION
If your device does not respond to the ARCAM CR80 after trying all codes
listed for your brand, or if your brand is not listed at all, try searching for
your code,
For example, to search for a code for your TV:
1
On the ARCAM CR80, press TV once.
2
Press and hold SET until the LED blinks twice, then release SET,
3
Enter 9 - 9 - 1 . The LED will blink twice.
4
Aim the remote control at the TV and slowly alternate between
pressing PWR and TV. Stop when the TV turns off.
NOTE: In the search mode, the ARCAM CR80 will send IR codes from its
library to the selected device, starting with the most popular code first
5
Press SET once to lock in the code.
6
To search for the codes of your other components, repeat steps 1 component you are searching for. NOTE: This feature is not applicable for the AMP key because it has only AVR 100 and AV8. CAUTION Do not the reset commands for other Universal Electronics warranty on this remote control will be invalidated. The ARCAM CR80 can be setup to learn a function from an original remote. energy efficient fluorescent lights could interfere with a learning event. Example: To learn the "mono/stereo" function from your original TV remote control onto the MODE(GUIDE)-key of your ARCAM CR80. 1 Place the ARCAM CR80 and your original remote control on a flat surface. Make sure the ends which you normally point at 2 On the ARCAM CR80; Press and hold the SET key until the LED blinks twice. The LED will blink once then twice. 3 Press 9 - 7 - 5 (the LED blinks twice). 4 Press the device key on the ARCAM CR80 remote to select the TV key). 5 Press the key on the ARCAM CR80 remote where you want to place the learned function (Example: MODE flash rapidly. 6 Press and hold the key (on your original remote control) that you key). 7 If you want to copy other functions within the same mode, simply 8 To exit the learning mode, press and hold the SET key until 9 To access a learned function, press SET then press the appropriate key, Deleting a learned function: To delete a learned function, either overwrite it with a new function on 1 On the ARCAM CR80; Press and hold the SET key until the LED blinks twice, The LED will blink once then twice. 2 Press 9 - 7 - 6 (the LED blinks twice). 3 Press the device key on the ARCAM CR80 remote to select the TV key). 4 Press the key to be deleted. 5 Again, press the key to be deleted.The LED will blink twice.
through 5, but substitute the appropriate key (i.e„ CBL, DVD, VCR,
TV, SAT, CD, or AUX) for the
one dedicated code in this mode which controls the Arcam AVR200,
remote controls on the CR80. Resets will permanently delete
key functions in the lower section of the remote, and the
To optimize success, the learning feature should be conducted in an area
where there is a low level of IR emission. High levels of "natural light" or
your device are facing each other. Keep the remotes at a
distance of 1 to 2 inches (2 to 5 cm).
mode to which you want to copy the learned function (Example:
want to copy until the LED blinks twice (Example: mono/stereo
repeat steps 5 until 7 pressing the next key you want to copy by
learning (up to limit of memory).
the LEO blinks twice.
the same key. or use the following sequence:
mode to which you want to copy the learned function (Example: