Troubleshooting – Directed Electronics DV2005 User Manual

Page 21

PROBLEM

SOLUTION

NO SOUND

1. Using the remote control, make sure the volume is not

lowered.

2. Check all audio cable connectors in the system for loose or

improper connections.

3. Test system components for proper power and operation.
4. Make sure that none of the components is in MUTE mode.

NO PICTURE

1. Check all video cable connectors in the system for loose or

improper connections.

2. Test system components for proper power and operation.
3. Make sure the monitor is turned on and set to the proper

channel or input zone.

NO REMOTE FUNCTION

1. Remove any objects that may be blocking the IR eye.
2. Make sure the remote IR eye is fully plugged into the

connector on the rear panel.

3. Test and replace any depleted remote control batteries.

PARTIAL OR NO DISPLAY

1. Inspect the disc for damage or dirt.
2. Check the monitor power and video cables for loose

connections.

3. Check the system setting to make sure all components are

set for the same system type.

DISC WON'T EJECT

1. Wait 10 seconds before pressing the EJECT button again.
2. If the disc won't eject with the EJECT button on the front

panel use the EJECT button on the remote control.

FORGOT YOUR PASSWORD

1. Press POWER from a cold start with the unit off. Press the

R. SKIP and F.SKIP buttons on the front panel and press
ENTER on the remote at the same time .

2. Press the SETUP button on the remote control to select

the Parental Mode. The Parental Mode is now unlocked as
indicated on the display. Press the DOWN button to select
Parental Mode. Press UP; the Create Password display will
appear. Press ENTER. You can now set your rating level and
change your password to a new number.

Troubleshooting