Directed Electronics DV2005 - Manual (Page 10)

10 © 2002 Directed Electronics, Inc.
REMOTE CONTROL BATTERY
■ Battery Installation
■ Pull down on the tab located on the
back of the remote control and pull
the battery cover off.
■ Insert the batteries while observing
the correct (+) and (-) polarities.
■ Click the battery cover back into
place on the back of the remote
control.
■ Service life of batteries - The batteries nor-
mally last for about six months, although
this depends on how often the remote
control is used.
■ If the remote control until fails to work,
even when it is operated near the player,
replace the batteries.
■ Use size AAA batteries.
■ Do not drop, step on, or otherwise impact
the remote control unit.
■ Do not mix old and new batteries.
■ If the remote control is not going to be
used for a long time, remove the batteries.
REMOTE CONTROL OPERATION RANGE
The remote control should not be used from
more than about 23 feet (7m) from the remote
control sensor and within about 60 degrees of
the front of the player. The operating distance
may vary according to the brightness of the
vehicle interior.
PRIOR TO USE
■ During playback, the TV volume may be at
a lower level then other source units. If
this is the case, adjust the volume to the
desired level.
■ Connect the DVD player according to the
instructions in the Installation section of
this guide.
■ If the DVD player is connected to the mon-
itor through a VCR, the picture may not be
played back normally. It is strongly recom-
mended not connecting the DVD player
through a VCR.
■ Check the following before using the DVD
player:
■ The monitor and audio equipment are
properly connected to the player.
■ The power for the monitor and audio
equipment is turned on.
■ The input setting for the monitor and
audio equipment is properly selected.
Remote Operation