Clock mode, Setting the clock time – COBY electronic CDRA147 User Manual
Page 8
Page 8
Coby Electronics Corporation
Engl
ish
www.cobyusa.com
Page 9
Clock Mode
Setting the Clock Time
Make sure the unit has been turned off before setting the
time.
To toggle the clock display between 12-hour mode and
24-hour mode:
Press and hold STOP/CLOCK ADJ [8] for 3 seconds.
The screen will display “12H” for 12-hour mode, or
“24H” for 24-hour mode.
To change modes again, wait until the normal clock
display returns, then press and hold STOP/CLOCK ADJ
[8] again.
The PM indicator will light up in 12-hour mode to
indicate PM hours.
To set the clock time:
Press STOP/CLOCK ADJ [8] once. The screen will begin
to flash.
While the screen is flashing:
Press SKIP NEXT/HOUR [11] to adjust the hour.
Press SKIP PREV/MINUTE [9] to adjust the
minutes.
Press STOP/CLOCK ADJ [8] to finish setting the time.