Avanti WC600CL - Manual (Page 7)

Warning yV'
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized Avanti Products service center.
1.
2
.
3.
5,
6.
7.
8.
9.
Reversing the Door Swing of Vour Wine Cooler
This wine cooler has the capability of either opening the door from the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the
opening direction, please follow these instructions.
NOTE: Before reversing the door, the power must be shut off.
All parts removed must be saved to do the reinstallation of the door.
Remove the two plugs (16) located in the back of top cover.
Remove the two screws (15) holding the top cover (12).
Lift the top cover up slightly from the back and then push it forward in order to unhook the
front of the top cover so it can be detached from the lock plate.
Hold the top cover and keep it from dropping to the ground because the v/ires are (14)
connected to the controller box underneath the top cover.
Remove the two screws (11) holding the controller box cover (17),
Remove the controller box cover (17) and unplug the connector (13) from the socket (18) on
the PCS board (10).
Place the top cover (12) on a padded surface to prevent scratching it.
Remove the upper right hinge (8), holding the door in place.
Lift the door and place it on a padded surface to prevent scratching it.
10. Lay the unit on its back against a solid surface at an angle of no less than 45 degrees.
11. Remove the upper hinge pin (9) from the hinge (8).
12. Replace the right upper hinge (8) to its original location.
13. Remove the two bolts (2) that hold the lower right hinge (5).
14. Remove the front leg (3) and the lower hinge pin (4) from the lower hinge (5).
15. Save the lower hinge assembly for later use.
16. Remove the lower left hinge (1) and transfer it to the opposite side, reversing the direction
180 degrees, where the lower right hinge (5) was previously located.
17. Transfer the lower hinge previously removed to the opposite side, where the left lower hinge
(1) was located, reversing the direction 180 degrees. Then insert the front leg (3), the two
bolts and the pin (4).
18. While holding the door in the closed position, secure the lower hinge on the left side of the
frame, fay screwing the bolts (2) in. Do not tighten until door is level.
19. Remove the upper left hinge (7) and insert the top hinge pin (9).
20. Replace the upper left hinge (7) with pin (9) to secure the door.
21. Plug the connector (13) to the socket (18) on the PCB (10) board.
22. Replace the controller box cover (12) by inserting the two screws previously removed in step
5.
23. Place the top cover by inserting all two screws previously removed in step 2.
24. Insert alt the plugs previously removed in step 1.