Harbor Freight Tools Model 94275 - Manual (Page 16)

SKU 94275 For technical questions, please call 1-800-444-3353. PAGE 16
Some versions of SKU 94274 Blast Cabinet do not have the eight pre-drilled 6.
mounting holes drilled into the back of the Blast Cabinet (holes are needed to
mount the Dust Reclaimer Kit). If you have one of those blast cabinets you will
need to have the eight mounting holes drilled as described in Step 7 below.
Have someone hold the Dust Reclaimer against the back of the cabinet while
7.
you attach the short 2” Hose (16A) to the Hose connector (48). Next press the
other end of the Hose (16A) over the 2” port of the Dust Reclamer. Press the
Dust Reclaimer all the way up against the back of the Blast Cabinet. Mark the
drilling hole locations through the mounting holes of part 32 while it is against
the back of the blast cabinet.
If you have a newer version of blast cabinet SKU 94275, there will be bolts and
8.
nuts already in the holes where the Dust Reclaimer will be attached to the Blast
Cabinet. Remove the eight bolts and nuts.
Attach the Dust Reclaimer to Blast Cabinet (SKU 94275) using the Bolts (51),
9.
Flat Washers (44), Spring Washers (45) and Nuts (46). Parts 45 and 48 attach to
the bolts from inside the cabinet. See Figures 11 and 12 below.
(48) Hose
Connector
Figure 11
Figure 12
REV 07g